Get Aruba ACMA-6.3 Dumps Questions [2022] To Gain Brilliant Result
ACMA-6.3 dumps - ExamsReviews - 100% Passing Guarantee
NEW QUESTION 24
What are the serial console commands used to factory default an AP?
- A. Write erase all
- B. Purge, save, boot
- C. Purge, write mem, reload
- D. Purge, save, reload
- E. Purge restart
Answer: B
NEW QUESTION 25
An Aruba AP 125 is capable of supporting which of the following network types? (Select three)
- A. 802.11w
- B. 802.11n
- C. 802.11a
- D. 802.11p
- E. 802.11b
Answer: B,C,E
NEW QUESTION 26
View the Server group screen shot above.
A company has provisioned the same VAP, AAA and SSID profiles at both its Miami and NY offices. This Server Group is applied for 802.1x authentication at both locations. The user's credentials are only found in the Miami Radius server "RadiusMiami". There is no Radius synchronization and both servers are reachable. What happens when the user attempts to authenticate?
- A. RadiusNY1 receives the request and returns a deny. The authentication request will then be sent to RadiusMiami.
- B. The controller recognizes the users Domain and sends the authentication request directly to RadiusMiami.
- C. RadiusNY1 receives the request and returns a deny. No other action is taken.
- D. The request is initially sent to RadiusNY1 then RadiusNY1 redirects the controller to send the authentication request to RadiusMiami
- E. The RadiusNY1 sends the request to RadiusMiami that replies to the controller
Answer: C
NEW QUESTION 27
Which of the following is NOT available for configuration in the startup wizard?
- A. WPA-PSK encryption
- B. Radius Server
- C. RF Plan
- D. Native VLANs on a per port basis
- E. Administrator and enable passwords
Answer: C
NEW QUESTION 28
Which roles must be configured via the startup wizard when captive portal is being configured (Select Two)
- A. Authenticated role
- B. Pre-Authentication role
- C. Unauthenticated role
- D. Roles are not used on the Aruba system
- E. The Logon Role
Answer: A,B
NEW QUESTION 29
Which is a Device Specific Attribute that can be evaluated in a user derivation rule?
- A. authentication server
- B. user login name
- C. location by AP Name
- D. controller IP
- E. controller Loopback address
Answer: C
NEW QUESTION 30
Which of these is NOT a valid license type? (Select two)
- A. RFprotect
- B. Content Security
- C. PEF NG
- D. Base AOS
- E. Application Security
Answer: D,E
NEW QUESTION 31
View the Server group and User Roles screen shots above.
A user associated to an SSID with 802.1x using this server group. RadiusNY returned a standard radius attribute of filter-Id with a value of "employee".
What Role will the user get?
- A. The User will get the Emp Role
- B. The User will get the Employee Role
- C. The User will get the 802.1x authentication default Role
- D. The User will get the employee Role
- E. The User will get the initial Role
Answer: C
NEW QUESTION 32
How many Aruba controllers can be added to a single mobility domain?
- A. Controllers supporting up to 6000 AP's
- B. 256 controllers with no more than 1024 subnets
- C. There is no controller limit
- D. 128 controllers supporting 2000 users
- E. 64 controllers of any type
Answer: C
NEW QUESTION 33
802.1X authentication takes place:
- A. After the user sees the captive portal page
- B. Prior to the user associating with the AP
- C. After the user has an IP address
- D. Once the IPSEC tunnel is up
- E. Prior to granting access to L2 media
Answer: E
NEW QUESTION 34
In the startup wizard the ports configuration screen allows you to do the following (Select three)?
- A. Specify the IP address of the Vlan
- B. Configure port channels
- C. Identify trunk ports
- D. Identify the native VLAN for a port
- E. Assign VLANs
Answer: C,D,E
NEW QUESTION 35
Time range is applied directly to which one of the following:
- A. Firewall Rule
- B. ROLE
- C. Profile
- D. Interface
- E. Firewall Policy
Answer: A
NEW QUESTION 36
Which of the following would be appropriate for standalone MAC Authentication?
- A. Barcode scanner
- B. Internal User
- C. Admin user
- D. Laptops
- E. Guest User
Answer: A
NEW QUESTION 37
What is the purpose of the validuser ACL?
- A. The validuser ACL is used during 802.1X authentication to check that the client is in the layer 3 user-table
- B. Before a client is added to the controller's user table, the validuser ACL is checked to make sure the client has a valid IP address
- C. When an AP needs to transmit data to a user, it checks the validuser ACL to make sure the user has a valid IP address
- D. A list of configured MAC addresses that define the valid users
- E. When a user transmits data through the controller, the validuser ACL is used to check if the user is in the layer 3 user-table
Answer: B
NEW QUESTION 38
Firewall policy should be written from:
- A. Most important resources first
- B. Least specific to most specific
- C. Most specific to least specific
- D. Order is not important
- E. Policies with the most rules 1st
Answer: C
NEW QUESTION 39
When configuring a guest WLAN via the WLAN section of the startup wizard, which
security option is NOT available?
- A. WEP encryption
- B. Direct access to the internet with no captive portal
- C. Captive portal with authentication via credentials
- D. Captive Portal with no authentication or registration
- E. Captive portal with email registration
Answer: A
NEW QUESTION 40
Which answer correctly orders the following AP boot processes as they occur?
a.AP Transfers OS from controller
b.AP builds GRE tunnel to the controller
c.AP determines IP address of the controller
d.AP Radio is enabled
- A. c, b, a, d.
- B. a, b, c, d.
- C. b, d, a, c.
- D. c, a, b, d.
- E. a, c, d, b.
Answer: D
NEW QUESTION 41
......
Get 100% Passing Success With True ACMA-6.3 Exam: https://easypass.examsreviews.com/ACMA-6.3-pass4sure-exam-review.html